Back to E-form Control Page
E-Form Change Control
Form Name : SE 28/01
Revision History
Revision Number |
Date |
Change |
2.0 |
|
Initial Release |
2.1 |
31/05/1999 |
Ctrl-? For help cell added Licensee’s Reference cells added. Issue number incremented Changed in results to have uncorrected Changed so that MB and MC do not have to provide GVM |
2.2 |
08/06/1999 |
Comparison of sound level results for second set of tests (MA & NA manual transmission) changed to look at results from column B not A. Engine speed bell corrected for tests 7 & 8. |
2.3 |
09/06/1999 |
Nominal Engine Speed calculations for Tests A to B corrected to avoid fractional values. |
2.4 |
07/07/1999 |
Changed Stationary Noise engine speed to confine
ESMP speed requirement to other than N group MD and ME Nomiinal engine speed adjusted to apply a small tolerance |
2.5 |
30/07/1999 |
Trigger added to error cells updated in revision 2.3 on Internal and System versions. |
2.6 |
14/09/1999 |
Image changed from FORS to DoTRS, issue and revision numbers incremented, issue date updated. |
2.7 |
13/12/1999 |
Test for bell in microphone distance error
cell in stationary test changed from <= to >= 1000 mm. Measured noise
reduction corrected to occur if mic <1000mm, cell moved. Check for if additional drive by test
results required amended to need >4 gears (not >3) and a power/weight
ratio below 75Kw/tonne etc. GVM only required for MA if power >140, num
gears >4, trans M. Check for whether pre-test results A, B
etc reported tightened up to force A in case of MA/NA, <=4 gears, MA >4
gears,>140kW, >75 power/weight.. The 'No' button for auto gears moved back
into place. "Test used to select approach
speed" cell auto fill-in improved. issue number replaced with revision
number. Engine speed for stationary tests with
acoustic shielding corrected in line with non shielded tests. |
2.8 |
08/03/2000 |
Changed label from GVM to GVM/Maximum
Loaded Vehicle Mass and added footnote. Error messages changed to suit. Created hidden cell to hold auto-fill value for "Test used to select approach speed" to avoid blanking user entered values on internal and system templates. |
2.9 |
5/02/2003 |
Update Departmental Logo. |
2.10 |
03/11/2003 |
Form was rejecting ECE 02 series approvals. Added Issue Num fields. Added Trigger check to all bell/cross cells. Added Attachment check. |
2.11 |
20/10/2004 |
Departmental logo updated. L series vehicles are not eligible for ECE
approval. Wording and warnings changed. Wording on 51/02 acceptance updated. Logic and order for completing speed and gear selection for MA
vehicles with > 140 kW, > 75 kW/GVM and speed in 3rd @ BB
> 61 revised. Checking logic for results of vehicle in
motion test readings changed to align with Circular 28/01-3-1. Stationary noise tests logic revised to be
easier to complete. |
2.12 |
9/02/2005 |
Question regarding governed engine speed removed. Saving disabled when Document Reference not completed. Fault concerning bells on additional third gear test (when automatic) rectified. |
2.13 |
10/07/2007 |
Logic for calculating final test result (average of second and third gear tests corrected. |
2.14 |
27/07/2012 |
Update Departmental Logo. |